Worn shaft? We repair it or remake it.

Shafts, bars, rods and piston rods, machined back to a working fit or made new from the old part, a sample or a drawing. By hand, in Peakhurst.

Family-runFitter and turner workshop
Since 1992Peakhurst, St George
Manual machinesLathes and a turret mill with digital readouts
Small and large partsOne-off, repair or a production run, to your drawing or sample

What we do

Shaft repair, by hand in Peakhurst

Turned, milled and fitted on manual machines with digital readouts. One part or a run.

Welding and hardening are arranged through trusted partners, with final machining done in-house.

How we work on a shaft

We measure what you have, work out what it needs to be, and tell you whether it is a repair or a remake before we start.

1
Measure it
The worn shaft, the housing it runs in, or the drawing if you have one.
2
Repair or remake
A worn journal can often be machined and sleeved. A cracked or badly worn shaft is remade.
3
Fit and check
Sizes checked against the drawing or the mating part before it leaves the workshop.

Common questions

If your question is not here, call Boris. A two-minute conversation usually sorts it out.

Do you need a drawing?
No. The old shaft or the part it fits into is enough to start. A sketch with a few sizes helps.
Can you match a shaft that is no longer made?
Yes. We work from the worn original or a sample and make a new one to suit the existing equipment.
Can you do more than one?
Yes. We do single shafts and batch and production runs of shafts.

Quote

Tell us what you need made or repaired. A drawing or a photo of the part helps. We can pick up and deliver.

Trusted by established engineering and industrial businesses across Sydney.